A typical wood ceiling order requires anywhere from 2-10 crates. Crates are typically 2-3ft wide, 8-10ft long and weight 500-3000lbs.
Learning Center
Touch-Up for Exterior Wood Ceilings
Have you ever wondered how a simple hair dryer can help you while installing wood ceilings at a jobsite? Exterior wood ceilings need protection. The…
How to Apply End Banding to Veneer Wood Ceilings
While it is similar to edge banding, end banding (or endbanding) is applied to the end grain rather than on the long horizontal edge of a veneer panel or wood ceiling product.
Field Cutting Deep Member Wood Grille Ceilings
When it comes to fielding cutting deep member grilles that have a larger depth, say 1×4 or 2×6, you are going to have to use different tools at your job site in order to process them.
Repairing Veneer Delamination
Veneer delamination is a separation of the surface layer from the core material caused by a failure of the bonding adhesive between the two layers.
Repairing Surface Damage
Surface damage often takes the form of scratches, dings, splits, holes, or gouges. This video walks through the basic steps of repair.
Repairing Chip-Out & Edge Damage
Minor edge damage and chip-out are the most common type of damage we see out in the field. It disrupts the edge of a wood member and will draw the eye to the area.
Repairing Minor Scratches and Scuffs
Scratches and scuffs on wood ceilings are anything in the finish that disrupts the sheen and draw the eye to the defect. This video walks through the basic steps of repair.
An Introduction to Wood Ceiling Repair
Not stopping to fix small, cosmetic defects during wood ceiling installations can result in expensive repairs after the Punch List comes out.
The 9Wood Finishing Process
The beauty of wood is widely known with the unique character that gives it an unmatched look. The 9Wood Finishing Process is how we keep it protected.
How to do Circular Cut-Outs for Grilles
Wood Grille Ceilings are very adaptive with other kinds of mechanical penetrations like sprinklers, speakers, or other circular cut-outs.
How to do Square Cut-Outs for Wood Grilles – 9Wood Field Guides
Grilles can be adapted to work with a lot of different mechanical penetration. This video we’ll be processing in-panel linear cut outs for 1100 series Cross Piece Grilles.